COMSPHERE 6800 Series Network Management System

Change Exception Reporting Thresholds (chert)

Use the chert command to set or change the failure thresholds for network tests supported by exception reports. Exception reports are generated when parameters measured for DATAPHONE II modems exceed the thresholds defined by this command. Results from the following commands may be run through exception reporting:

Automatic Network Test (disruptive test)

Circuit Loss Inbound (disruptive test)

Circuit Loss Outbound (disruptive test)

Digital Test (disruptive test)

End-to-End Test (disruptive test)

Offline Test (disruptive test)

Receive Signal Level

Receive Signal Quality

Report Terminal Power

Signal Profile

For information about the measurements obtained by these commands, refer to the individual command description in this chapter.

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

Access Level: Data Technician, Manager, System Administrator

Abbreviation: chert

Restrictions: None

Routine:Yes

Schedule:Yes

Related Commands: Display Exception Reporting Thresholds (dsert)

Exception Reports (er)

Change Exception Reporting Thresholds Input Forms

There are two pages for the Change Exception Reporting Thresholds input form.

Page 1

Page 1 displays the network test parameters for which exception reporting is applicable. For each parameter, specify the threshold for which the results are to be reported.

Figure 2-13 is a sample of Page 1 of the Change Exception Reporting Thresholds input form.

2-48

January 1997

6800-A2-GB31-20

Page 71
Image 71
Paradyne 6800 manual Change Exception Reporting Thresholds chert, Change Exception Reporting Thresholds Input Forms