Paradyne 6800 manual End-to-End Test eet, End-to-End Test Input Form, Abbreviation eet

COMSPHERE 6800 Series Network Management System

End-to-End Test (eet)

(Disruptive)

Use the eet command to test the primary data channel between a specified COMSPHERE 3400/4400 Series control modem, a COMSPHERE 3600 Series DSU, a COMSPHERE 3600 Series DBM, a DATAPHONE II APL modem or DSU, and a tributary.

This command checks for transmission errors in a specified number of blocks. The blocks are sent from the control device to the tributary, then back. Both control and tributary devices check the transmission for errors, with the control device counting the errors in each direction. Intermediate results are displayed every 256 blocks.

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

Access Level: Data Technician, Manager, System Administrator

Abbreviation: eet

Alternate: ee

Restrictions: End-to-end testing of multiple links consisting solely of COMSPHERE devices or solely of DATAPHONE II devices is supported by this command; a mix of COMSPHERE and DATAPHONE II devices is not supported.

Routine:Yes

Schedule:Yes

Related Commands: None

End-to-End Test Input Form

A sample End-to-End Test input form is shown in Figure 2-50.

2-156 January 1997 6800-A2-GB31-20