COMSPHERE 6800 Series Network Management System

Service Line (sl)

Use the sl command to allow a ninth service telephone line to be assigned to one of the eight DATAPHONE II or COMSPHERE 3800 Series Direct Distance Dial (DDD) control modems in a carrier overseen by a single Shared Diagnostic Unit (SDU).

Placing the modem in the service line state makes the phone line associated with the modem busy, and transfers the modem to the service line for testing purposes.

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

Access Level: Data Technician, Manager, System Administrator

Abbreviation:

Abbreviation: sl

Restrictions: None

Routine:Yes

Schedule:Yes

Related Commands: None

Service Line Input Form

This input form contains the following fields:

Device(s) (Required field)

Enter the device(s) to which this command will be sent. One or more devices may be specified. Standard addressing format applies to the input. For information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management System User's/System Administrator's Guide.

Service line state (Required field)

Enter service-line to assign the service telephone line to the specified device(s). Enter release to release the device(s) from the service line.

A pop-up menu is available listing valid selections.

Service Line Results Form

This results form lists device information for each device specified, displays the requested service line state (service-lineor release), and indicates whether or not the command was successfully executed.

2-198

January 1997

6800-A2-GB31-20

Page 221
Image 221
Paradyne 6800 manual Service Line sl, Service Line Input Form, Service Line Results Form, Service line state Required field