Modem/DSU Commands

Signal Profile (sp)

Use the sp command to estimate facility parameters for a leased or switched transmission facility. This command can be sent to DATAPHONE II APL and DDD modems.

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

Access Level: Help Desk, Data Technician, Manager, System Administrator

Abbreviation:

Abbreviation: sp

Restrictions: None

Routine:Yes

Schedule:Yes

Related Commands: Receive Signal Level (rsl)

Receive Signal Quality (rsq)

Signal Profile Input Form

This input form contains the following field:

Device(s) (Required field)

Enter the device(s) to which this command will be sent. One or more devices may be specified. Standard addressing format applies to the input. For information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management System User's/System Administrator's Guide.

Signal Profile Results Form

A sample Signal Profile results form is shown in Figure 2-62.

6800-A2-GB31-20

January 1997

2-199

Page 222
Image 222
Paradyne 6800 manual Signal Profile sp, Signal Profile Input Form, Signal Profile Results Form