COMSPHERE 6800 Series Network Management System

Change Protocol Mode (chpm)

(Disruptive)

Use the chpm command to change the protocol mode of a COMSPHERE device (3400/4400 Series modem, 3600 Series DSU, or 3600 Series DBM) and all of its downstream devices. The Change Protocol Mode (chpm) command will generally be used to change the diagnostic mode of COMSPHERE devices from dataphone II to advanced.

NOTE

Before executing this command, be sure there are no active faults on the local control device or on the circuit, and that there are no devices in test mode. If there are, use the abort command or wait until the test is completed before executing the chpm command.

When the chpm command is executed, the 6800 Series causes the following events to occur:

A subnetwork abort is issued to the specified control device.

The diagnostic mode of the control device and all downstream devices on the circuit are changed.

The new link level addresses of the control device and all of the downstream devices are calculated and checked for uniqueness.

Device profiles are updated with new link level and alternate mode addresses and the link level address of the associated DBM is also updated.

The System polling field in the control device's profile is set to cc active. (If the control device should be skipped during polling, execute the Edit Device Profile (eddp) command to change the System polling field to skipped. (For an affected downstream device, if the System polling field of its device profile was set to extended poll, this value will be changed to skipped.)

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

2-68

January 1997

6800-A2-GB31-20

Page 91
Image 91
Paradyne 6800 manual Change Protocol Mode chpm