Modem/DSU Commands

Display External Leads States (dsels)

Use the dsels command to display the states of two external control interface leads which are presented as outputs at the connectors on a COMSPHERE 3400/4400 Series modem, a COMSPHERE 3600 Series DSU/DBM or a COMSPHERE 3800 Series modem. To change the states of the leads, or for additional information on the fields that display when you access the dsels command, refer to the Change External Leads States (chels) command.

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

Access Level: Help Desk, Data Technician, Manager, System Administrator

Abbreviation: dsels

Restrictions: None

Routine:Yes

Schedule:Yes

Related Commands: Change External Leads States (chels)

Display External Leads States Input Form

This input form contains the following field:

Device(s) (Required field)

Enter the device(s) whose external lead states are to be displayed. One or more device(s) may be specified. Standard addressing format applies to the input. For information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management System User's/System Administrator's Guide.

6800-A2-GB31-20

January 1997

2-129

Page 152
Image 152
Paradyne 6800 manual Display External Leads States dsels, Display External Leads States Input Form