Paradyne 6800 manual Display Address dsa, Display Address Input Form, Display Address Results Form

COMSPHERE 6800 Series Network Management System

Display Address (dsa)

Use the dsa command to display the network address and carrier/slot location of a COMSPHERE 3400/4400 Series modem, a COMSPHERE 3600 Series DSU, a COMSPHERE 3600 Series DBM, or a COMSPHERE 3800 Series modem.

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

Access Level:	Help Desk, Data Technician, Manager, System Administrator
Abbreviation:	dsa
Restrictions:	This command will execute only for a device with a correct serial number
	entry in the device profile.
Routine:	Yes
Schedule:	Yes
Related Commands:	Change Address (cha)

Display Address Input Form

This input form contains the following field:

Device(s) (Required field)

Enter the device(s) whose addresses are to be displayed. One or more devices may be specified. Standard addressing format applies to the input. For information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management System User's/System Administrator's Guide.

Display Address Results Form

The results form displays device information for each device specified. The Address field in the header displays the link level address in the format link level address/serial number where link level address is the address of the upstream device. In addition, the form displays the network address of the device, and the carrier and slot where the device is located.

An error message displays if there is no serial number for the device in the device profile.

2-118 January 1997 6800-A2-GB31-20