Paradyne 6800 manual Training Time tt, Training Time Input Form

Modem/DSU Commands

Training Time (tt)

Use the tt command to obtain training time information for a COMSPHERE 3400/4400 Series control modem. The control modem determines its required training time and actual training time, and updates these values at 1-minute intervals. The training times shown represent the longest value over the 1-minute interval.

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

Access Level: Help Desk, Data Technician, Manager, System Administrator

Abbreviation: Abbreviation: tt

Restrictions: None

Routine:Yes

Schedule:Yes

Related Commands: None

Training Time Input Form

This input form contains the following field:

Device(s) (Required field)

Enter the device(s) for which the training time information will be obtained. One or more devices may be specified. Standard addressing format applies to the input. For information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management System User's/System Administrator's Guide.

6800-A2-GB31-20 January 1997 2-205