Modem/DSU Commands

Figure 2-13. Change Exception Reporting Thresholds Input Form, Page 1

This input form contains the following fields:

Request Terminal Power: list if (Required field)

Specify whether the exception report for the Report Terminal Power (rtp) command will indicate an on or off (default) power state of the terminal connected to a device's data channel. A pop-up menu is available listing valid selections.

Digital: list if > nnnn errors (Required field)

Enter the exception reporting threshold for the number of bits in error (determined when a Digital Test (dt) command is run). Valid entries are from 0 (default) through 1000.

End to End: list if > nnnn inbound errors (Required field)

Enter the exception reporting threshold for the number of inbound bits in error (determined when an End-to-End Test (eet) command is run). Valid entries are from 0 (default) through 1000.

End to End: list if > nnnn outbound errors (Required field)

Enter the exception reporting threshold for the number of outbound bits in error (determined when an End-to-End Test (eet) command is run). Valid entries are from 0 (default) through 1000.

Circuit Loss Inbound: list if > nn dB (Required field)

Enter the exception reporting threshold for inbound circuit loss in decibels (determined when the Circuit Loss Inbound (cli) command is run). Valid entries are from 0 through 30. The default is 16.

A pop-up menu is available listing valid selections.

6800-A2-GB31-20

January 1997

2-49

Page 72
Image 72
Paradyne 6800 manual Request Terminal Power list if Required field, Digital list if nnnn errors Required field