COMSPHERE 6800 Series Network Management System

Display [Device] Poll List (dspl)

Use the dspl command to display the poll list of a COMSPHERE 3400/4400 Series modem, a COMSPHERE 3900 Series modem, or COMSPHERE 3600 Series DSU, a DATAPHONE II APL modem, DSU or Shared Diagnostic Unit (SDU). Use the Acquire [Device] Poll List (acpl) command to establish a poll list, and the Change [Device] Poll List (chpl) command to add or delete devices to or from the poll list.

Polling is the process by which alarms from devices in the network are automatically reported to the NMS. Once a poll list is established for a device, the device monitors everything on its poll list for health and status.

For most commands, NMS enables you to specify the destination for the command's results and schedule its execution. If the last page of the input form cannot accommodate the Destination for results and Schedule execution fields, an additional page is provided. For a complete description of these fields, refer to Chapter 1, Introduction.

Access Level: Help Desk, Data Technician, Manager, System, Administrator

Abbreviation: dspl

Restrictions: None

Routine:Yes

Schedule:Yes

Related Commands: Acquire [Device] Poll List (acpl)

Change [Device] Poll List (chpl)

Display [Device] Poll List Input Form

This input form contains the following field:

Device(s) (Required field)

Enter the device(s) whose poll lists are to be displayed. One or more devices may be specified. Standard addressing format applies to the input. For information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management System User's/System Administrator's Guide.

2-134

January 1997

6800-A2-GB31-20

Page 157
Image 157
Paradyne 6800 manual Display Device Poll List dspl, Display Device Poll List Input Form