Xerox C123/C128 M123/M128 123/128 manual Hp-Ux, Using the Command Window TTY Method

UNIX TCP/IP Installation

4.The machine can be designated as the location of the default print queue. It will then be unnecessary to include the PrinterName in the lpr command line.

1)To designate the machine for the default print queue, add the following to the /etc/printcap file. This is in addition to the information entered in the previous step:

lp PrinterName:\

:lp=:\

:rm=PrinterName:\

:mx#0:\

:sd-/var/spool/lpd/PrinterName:

5.Create the spool directory identified in the printcap file and set the access attributes, as shown in the example below. The spool directory should be located on a disk partition large enough to hold copies of documents that will be submitted.

cd /var / spool / lpd

mkdir PrinterName

chmod 744 PrinterName

HP-UX

Follow the steps below to set up an HP-UX workstation to communicate with the machine.

1.Log in as root at a client and add the machine to the /etc/hosts file. For example:

Ip address [tab] PrinterName

2.Verify connectivity to the machine, by using a UNIX command such as ping from a terminal command window, as shown in the following example:

ping PrinterName

NOTE: Select CTRL+C to cancel the ping command.

3.There are two methods to install the machine on an HP-UX workstation. Choose the method that will be used to complete the installation and refer to the appropriate page:

Using the Command Window TTY Method – page 53

Using the System Administrator Manager (SAM) GUI Method – page 54

Using the Command Window TTY Method

Follow the steps below to use the command window to manually enter command strings.

1.Open a command window on the desktop. From the command prompt (#), enter the information below. Remember that UNIX commands are case-sensitive.

Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 System Administration Guide 53