
EtherTalk Installation
Initially, boot the EtherTalk port.
1.Connect the machine to the network.
2.Display the [System Settings] screen.
NOTE: For more information about how to display the [System Setting] screen, refer to the Setups chapter of the User Guide.
3.Select [Network Settings].
4.Select [Port Settings].
5.Select [EtherTalk], and then [Change Settings].
6.Select [Port Status] and then [Change Settings].
7.Select [Enabled], and then [Save].
Next, establish TCP/IP.
1.Display the [System Settings] screen.
NOTE: For more information about how to display the [System Setting] screen, refer to the Setups chapter of the User Guide.
2.Select [Network Settings].
3.Select [Protocol Settings].
4.Select [TCP/IP – Get IP Address], and then [Change Settings].
5.Select a method for establishing an IP address from [DHCP], [BOOTP], [RARP], [DHCP/Autonet], or [Manual], and then select [Save].
NOTE: Use the DHCP server together with the Windows Internet Name Server (WINS) server.
If you selected [Manual] in step 5, then complete steps 6 to 11 to enter the [Protocol Settings]. Otherwise, complete step 14.
6.Select [TCP/IP – IP Address], and then [Change Settings].
7.Use the keypad on the screen to enter the IP Address for the machine in the format “xxx.xxx.xxx.xxx”. Enter relevant values (0 to 255) into the highlighted field and select [Next]. The next 3 digits are highlighted. When you have finished entering all values, select [Save].
8.Select [TCP/IP – Subnet Mask], and then [Change Settings].
9.Using the same method as in step 7, enter the Subnet Mask.
10.Select [TCP/IP – Gateway Address] and [Change Settings].
11.Using the same method as in step 7, enter the Gateway Address.
NOTE: If you do not wish to set the Gateway Address, enter “0.0.0.0”.
12.Select [TCP/IP - IP Filter], then [Change Settings].
13.Select [On] to filter access to the machine.
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 System Administration Guide | 69 |