7 TCP/IP (LPD or Port9100)
This chapter explains how to set up the machine to print from a Windows computer through LPD or Port9100. The following information is provided.
Information Checklist – page 79
TCP/IP (LPD or Port9100) Environments – page 80
TCP/IP (LPD or Port9100) Installation – page 80
Installation Procedure – page 80
Network Communication Setup – page 81
Workstation Setup – page 82
Test Print – page 83
Information Checklist
Before starting these procedures, make sure that the following items are available or have been performed.
| Item | By |
|
| |
|
| |
An existing operational network utilizing TCP/IP is required. These | Customer | |
procedures are not designed to install a network. |
| |
|
| |
Obtain and record the following information: | Customer | |
• | IP address |
|
• | Gateway address |
|
• | Subnet mask |
|
• | Host name |
|
Refer to the glossary for additional information about the Gateway |
| |
Address and Subnet mask, if needed. |
| |
|
| |
Test the machine to make sure that it is installed fully and functioning | Customer | |
correctly. |
| |
|
| |
Install the print driver. | Customer | |
|
|
|
If problems are encountered during machine setup, refer to the Problem Solving chapter for assistance.
CAUTION: Do not connect the network cable to the machine until instructed to do so.
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 System Administration Guide | 79 |
