5 EtherTalk
This chapter explains how to set up the machine to operate on an EtherTalk network. The following information is provided.
Information Checklist – page 67
EtherTalk Environments – page 68
EtherTalk Installation – page 68
Installation Procedure – page 68
Network Communication Setup – page 68
Workstation Setup – page 70
Test Print – page 70
Information Checklist
Before installing EtherTalk on the machine, make sure that the following items are available or have been performed.
| Item | By |
|
| |
|
| |
An existing operational EtherTalk network with Macintosh workstations | Customer | |
equipped with Ethernet network interface cards is required. These |
| |
procedures are not designed to install an EtherTalk network. |
| |
|
| |
Macintosh System versions 7.5 or later, 8.x, 9.x, or Mac OS X 10.2 | Customer | |
|
| |
Obtain and record the following information: | Customer | |
• | IP address |
|
• | Gateway address |
|
• | Subnet mask |
|
• | Host name |
|
Refer to the glossary for additional information about the Gateway |
| |
Address and Subnet mask, if needed. |
| |
|
| |
Test the machine to make sure that it is installed fully and functioning | Customer | |
correctly. |
| |
|
| |
Install the Adobe PS print driver, or PPD (optional). | Customer | |
|
|
|
If problems are encountered during the machine installation, refer to Problem Solving chapter for assistance.
CAUTION: Do not connect the network cable to the machine until instructed to do so.
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 System Administration Guide | 67 |
