10IPP (Internet Printing Protocol)
7.Use the keypad on the screen to enter the IP Address for the machine in the format “xxx.xxx.xxx.xxx”. Enter relevant values (0 to 255) into the highlighted field and select [Next]. The next 3 digits are highlighted. When you have finished entering all values, select [Save].
8.Select [TCP/IP – Subnet Mask], then [Change Settings].
9.Using the same method as in step 7, enter the Subnet Mask.
10.Select [TCP/IP – Gateway Address], then [Change Settings].
11.Using the same method as in step7, enter the Gateway Address.
NOTE: If you do not wish to set the Gateway Address, enter “0.0.0.0”.
12.Select [TCP/IP - IP Filter], then [Change Settings].
13.Select [On] to filter access to the machine.
NOTE: If you do not wish to use the IP filter feature, select [Off].
NOTE: Use CentreWare Internet Services to register the IP addresses which are not allowed to access the machine. Refer to the CentreWare Internet Services chapter of the User Guide.
14.When you have finished establishing TCP/IP, select [Close] from the [Protocol Settings] screen.
Workstation Setup
Install print drivers on each client workstation that will be sending print jobs to the machine, and map to the machine as a printer. Refer to the HTML document in CentreWare Utilities
Test Print
To make sure that the machine has been installed on the network correctly a test print should be submitted from a client workstation. Perform the following steps.
1.Open a document on a client workstation.
2.Select the machine as the printer to which the selected document will be sent.
3.Print the document on the machine and verify that it prints correctly.
4.Make sure that the driver is installed on every workstation that will be sending jobs to the machine.
5.Repeat the test for all workstations that will be sending jobs to the machine.
The installation process is now complete.
If the test print fails, refer to the Problem Solving chapter for assistance.
96 | Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 System Administration Guide |
