6 Microsoft Networking
This chapter explains how to set up the machine to operate on a Microsoft network. The following information is provided.
Information Checklist – page 71
SMB Environments – page 72
SMB Installation – page 73
Installation Procedure – page 73
Network Communication Setup – page 73
Workstation Setup – page 75
Test Print – page 75
Changing the Settings – page 75
Procedure – page 75
Setting Format of config.txt – page 76
Information Checklist
Before starting the Microsoft networking installation procedures, make sure that the following items are available or have been performed.
| Item | By |
|
| |
|
| |
An existing operational Microsoft network is required. These procedures | Customer | |
are not designed to install a Microsoft network. |
| |
|
| |
Obtain and record the following information, if required: | Customer | |
• | IP address |
|
• | Gateway address |
|
• | Subnet mask |
|
• | Host name |
|
Refer to the glossary for additional information about the Gateway |
| |
Address and Subnet mask, if needed. |
| |
|
| |
Test the machine to make sure that it is installed fully and functioning | Customer | |
correctly. |
| |
|
| |
Install the print driver. | Customer | |
|
|
|
If problems are encountered during the installation, refer to the Problem Solving chapter for assistance.
CAUTION: Do not connect the network cable to the machine until instructed to do so.
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 System Administration Guide | 71 |
