Xerox C123/C128 M123/M128 123/128 manual USB Port Communication Setup, Workstation Setup

USB Port Installation

USB Port Communication Setup

This section describes how to set up USB communication on the machine. The following parameters can be set depending on your requirements. These setups must be done without the USB cable connected.

This procedure is used to set up the USB communication parameters of the machine. At the machine, perform these steps.

NOTE: CentreWare Internet Services can also be used to configure the machine. Refer to the CentreWare Internet Services chapter of the User Guide.

1.Display the [System Settings] screen.

NOTE: For more information about how to display the [System Settings] screen, refer to the Setups chapter of the User Guide.

2.Select [Network Settings].

3.Select [Port Settings].

4.Select [USB], and [Change Settings].

5.Select the item to be set, and then select [Change Settings].

6.Select the required value, then [Save].

7.Repeat step 5 and 6, if required.

Depending on your requirements, select the following communication parameters on the machine.

•Port Status

•Print Mode

•PJL

•Auto Eject Time

•Adobe Communication Protocol

NOTE: Adobe Communication Protocol can be set when the PostScript Kit (optional) has been installed.

Workstation Setup

Before starting Workstation Setup, make sure that the USB cable is disconnected from the computer.

Then perform the following steps.

1.Refer to the HTML document in CentreWare Utilities CD-ROM or document provided with the optional PostScript Kit, and install the print drivers for the machine on all the workstations that will be sending jobs to the machine.

2.Continue with Test Print on page 92.

Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 System Administration Guide 91