Chapter 6 Avaya P130 CLI

Set interface ppp command

Use the set interface ppp command to configure the IP parameters of the device’s PPP interface. No PPP connection can be established with the device until it is configured with a non-null IP address and net-mask. This IP address is a dummy address shared only between the two peers. It must be taken from an IP sub-net different than the IP sub-net of the agent.

The syntax for this command is:

set interface ppp <ip-address> <net-mask>

Example:

P130-1# set interface ppp 149.49.34.125 255.255.255.0

Interface PPP has its IP address set.

Set interface ppp enable enable-always disable off reset Command

Use the set interface ppp command to disconnect the PPP session, or to reset the connected modem. Use the provided on demand DB-25 to RJ45 connector for plugging-in the RJ-45 to RJ-45 delivered cable into the modem’s DB-25 connector from one side, while the other cable’s side RJ-45 connector should be plugged into the device’s Console RJ-45 port of any box..

The syntax for this command is:&_

set interface ppp {enable enable-always disable off reset}

enable

Enable the use of PPP, and thus to enter the modem mode.

enable-always

Entering the Modem mode every time that the proprietary

 

modem cable is plugged into the console port.

disable

Disable the use of PPP, and thus to enter the terminal mode.

off

Keyword to disconnect the active PPP session.

reset

Keyword to reset the connected modem.

Example:

P130-1# set interface ppp off

PPP session disconnected.

P130-1# set interface ppp reset

PPP has reset the connected modem.

100

Avaya P130 User’s Guide

Page 114
Image 114
Avaya P130 manual Set interface ppp command, Set interface ppp ip-address net-mask