Avaya P130 manual Set port channel Command, Set port channel modnum/portlist on off LAG-name

Chapter 6 Avaya P130 CLI

Set port channel Command

Use the set port channel command to enable or disable a Link Aggregation Group (LAG) interface on the module. You can also add or remove a port from an existing LAG. All ports in the LAG are configured with the base ports' parameters such as port speed, duplex mode, VLAN ID, tagging mode, priority level. When adding a port to an existing LAG, type the same LAG-name (or no LAG-name), otherwise you will get an error message. The added port must belong to the same connector group - refer to the "LAG" indication on device's front panel. When a port is removed from a LAG, it becomes disabled.

The syntax for this command is:

set port channel <mod_num>/<port_list> {on off} <LAG-name>

<mod-num> <port_list> <LAG_name>

Example:

Module number

A list of ports to be aggregated, separated by commas.

Name for the LAG interface.

P130-1# set port channel 1/6,18 on server2

Port 1/6 channel mode set to on

Port 1/18 was added to channel

Set port redundancy enable/disable Command

Use the set port redundancy command to enable or disable the defined redundancy schemes. Using this command will not delete existing redundancy entries.

Note: You must disable Spanning Tree before you can enable redundancy.

The syntax for this command is:

set port redundancy {enabledisable}

Example:

P130-1# set port redundancy enable

All redundancy schemes are now enabled

Avaya P130 User’s Guide 77