Avaya manual P130-1# set port duplex 1/2 full Port 1/2 set to full-duplex

Chapter 6 Avaya P130 CLI

Example:

To set port 2 on module 1 to full duplex:

P130-1# set port duplex 1/2 full

Port 1/2 set to full-duplex.

P130-1#

Set port flowcontrol Command

Use the set port flowcontrol command to set the send/receive flow-control frames (whether proprietary or IEEE 802.3x) for a full duplex module port. Each direction can be configured separately.

This command is supported on Fast and Gigabit Ethernet switching ports.

The syntax for this command is:

set port flowcontrol {receive send all}<mod_num/ port_num>{off on prop}

receive	Indicates whether the port can receive administrative status
	from a remote device. Available only for Gigabit Ethernet
	modules with negotiation set to off.
send	Indicate whether the local port can send administrative status
	to a remote device. Available only for Gigabit Ethernet
	modules with negotiation set to off.
all	Send and receive (symmetric flow control).
mod_num	Module number
port_num	Number of the port on the module
off	Used with receive to turn off an attached device's ability to
	send flow-control packets to a local port. Used with send to
	turn off the local port's ability to send administrative status to a
	remote device.
on	Used with receive to require that a local port receive
	administrative status from a remote device. Used with send,
	the local port sends administrative status to a remote device.
prop	Proprietary flow control.

74 Avaya P130 User’s Guide