Chapter 6 Avaya P130 CLI
Set port name Command
Use the set port name command to configure a name for a port. If you do not specify a name, the port name remains empty.
The syntax for this command is:
set port name <mod_num>/<port_num> [<name>]
mod_num | Module number |
port_num | Number of the port on the module |
<name> | Name assigned to the port. |
Example:
P130-1# set port name 1/21 arthur
Port 1/21 name set.
Set port trap Command
Use the set port trap command to enable/disable generic SNMP uplink / downlink traps from a port.
The syntax for this command is:
set port trap <mod_num>/<port_num> {enable disable}
mod_num | Module number |
port_num | Number of the port on the module |
enable | Enables generic SNMP uplink/downlink traps from a port |
disable | Disables generic SNMP uplink/downlink traps from a port |
Example:
P130# set port trap 1/21 enable
Port 1/21 up/down trap enabled.
76 | Avaya P130 User’s Guide |
