Avaya P130 Set port speed Command, Set port speed modnum/portnumspeed, Set port duplex Command

Chapter 6 Avaya P130 CLI

Set port speed Command

Use the set port speed command to configure the speed of a port or range of ports.

In autonegotiation mode, the port's speed is determined by autonegotiation. You cannot set the speed type to 10 or 100 when autonegotiation is enabled.

The syntax for this command is:

set port speed <mod_num/port_num><speed>

mod_num	Module number
port_num	Number of the port on the module
<speed>	Set port speed to 10, or 100 Mbps

Example:

To configure port 2 on module 1 port speed to 10 Mbps:

P130-1# set port speed 1/2 10MB

Port 1/2 speed set to 10 Mbps.

Set port duplex Command

Use the set port duplex command to configure the duplex type of an Ethernet or Fast Ethernet port or range of ports.

You can configure Ethernet and Fast Ethernet interfaces to either full duplex or half duplex. The duplex status of a port in autonegotiation mode is determined by autonegotiation. An error message is generated if you attempt to set the transmission type of autonegotiation Fast Ethernet ports to half- or full-duplex mode.

The syntax for this command is:

set port duplex <mod_num/port_num> {full half}

mod_num	Module number
port_num	Number of the port on the module
full	Keyword to specify full-duplex transmission
half	Keyword to specify half-duplex transmission

Avaya P130 User’s Guide 73