Chapter 6 Avaya P130 CLI
FlowControl Commands
Set internal buffering Command
Use the set internal buffering command to set the size (either Maximum or Minimum) of the Receive (Rx) buffer allocated to each port of the specified module. This command is meaningless when any port of the module is operating with flow control ON. You must reset the switch after setting the internal buffering parameters.
The syntax for this command is:
set internal buffering <mod_num> {maxmin}
max | Sets the internal receive buffer to its maximum size. |
min | Sets the internal receive buffer to its minimum size (this is the |
| Default). |
Example:
Done.
Show internal buffering Command
Use the show internal buffering command to show the size options (Maximum, Minimum, or Medium) of the Receive (Rx) buffer allocated to each port of the specified module.
The syntax for this command is:
show internal buffering [<mod_num>]
<mod_num> Module number
Example:
Module Internal Buffer
1 med
Set port flowcontrol Command
See Set port flowcontrol Command on page 74
Show port flowcontrol Command
See Show port flowcontrol Command on page 67.
Avaya P130 User’s Guide | 81 |
