Cisco Systems D14595.03 Shutting down and restarting the Content Server, LCD panel operations

Shutting down and restarting the Content Server

Shutting down and restarting the Content Server

On Content Servers equipped with an LCD panel, this can be used to shut down or restart. On Content Servers which do not have a LCD panel, you should use a PC connected to the Content Server serial port via a serial cable. Cisco recommends that you end all calls on the Content Server before you shut down; otherwise the conferences may fail.

Note: If calls are in progress when the shut down occurs, the recorded conferences appear in the Recorded conferences list but may be unusable. They can be deleted in the normal way.

LCD panel operations

Restarting the Content Server using the LCD panel

1.Make sure that the Content Server is not recording or transcoding; that is, the LCD displays 'online'.

2.Press to display the main menu.

3.Go to Commands > Restart.

4.Select Yes to confirm.

You will see the message 'Restarting' on the LCD panel.

Shutting down the Content Server using the LCD panel

1.Make sure that the Content Server is not recording or transcoding; that is, the LCD displays 'online'.

2.Press to display the main menu.

3.Go to Commands > Shutdown.

4.Select Yes to confirm.

5.The Content Server shuts down. When you see the message 'Power off' on the LCD or when the LAN1 and HDD LEDs stop blinking, you can turn off the power using the switch at the back of the unit.

LCD status display and button functions

online		The Content Server is ready to accept calls and transcode outputs but none are
		currently in progress.
1-5 calls		Calls are in progress on the Content Server.
transcoding		The Content Server is transcoding.
Server modes
config reload		The Content Server is in Reloading Configurations mode. In Reloading Configurations
		mode, the Content Server does not accept new calls.
1-5 calls (cnfg)		Calls are in progress and the Content Server is in Reloading Configurations mode.
trans (cnfg)		The Content Server is transcoding and is in Reloading Configurations mode.
idle		The TCS Wizard is running. In Idle mode, the Content Server does not accept new
		calls or process new transcoding jobs.
	Cisco TelePresence Content Server 4.1 printable online		Page 103 of 121