Cisco Systems D14595.03 manual Terminal emulator program operations, Error states, Buttons

	Shutting down and restarting the Content Server
1-5 calls (idle)	The TCS Wizard has started while there is a call in progress.
trans (idle)	The TCS Wizard has started while there is a transcoding process in progress.
maintenance	The Content Server is in a cluster and has been set to Maintenance mode. The
	Content Server will not accept new calls or process new transcoding jobs.
1-5 calls	Calls are in progress and the Content Server is in Maintenance mode.
(maint)
trans (maint)	The Content Server is transcoding and is in Maintenance mode.
upgrading	This Content Server, or a Content Server in the cluster, is being upgraded.
Error states
Error	The Content Server is out of disk space or has lost connection to the NAS.
No network	The Content Server has no connection to the network.
Buttons
	Enters Edit mode, confirms an entry.
	Returns to the previous menu, exits Edit mode without saving.
	Moves between menu items, moves between values in a numerical address and
and	modifies numerical values.

Terminal emulator program operations

Restarting the Content Server using a PC connected to the serial port

1.Connect the supplied serial cable from the serial port on the back of the Content Server to the serial port on a PC.

2.Start a terminal emulator program on the PC by going to All Programs > Accessories > Communications > HyperTerminal. (If HyperTerminal is not installed, download a terminal emulator program from the Internet; for example, puTTY.)

3.Open a new connection and enter a name for the connection.

4.Configure the connection to use the PC’s serial port as follows:

a.Set Baud rate to 115200 bps.

b.Set Data bits to 8.

c.Set Parity to None.

d.Set Stop bits to 1.

e.Set Flow control (hardware and software) to None.

5.Click OK.

6.Press Enter to display the main menu.

Cisco TelePresence Content Server 4.1 printable online Page 104 of 121