13-4
Cisco WAN Manager User’s Guide
Version 10.5, Part Number 78-12945-01 Rev. D0, August 2003
Chapter13 Saving and Restoring Node Configurations
Switch CLI Save and Restore
Figure13-3 Configuration Restore window
Switch CLI Save and Restore
Release 10 of CWM ConfigSave and Restore also allows saving and restoring of nodes through the
Command Line Interface as foll ows :

Saving Node Configurations for BPX and IGX Nodes

This section describes how to save and restore node configurations. To save or restore a node’s
configuration, the Configuration Save/Restore option should be enabled on the node.
Step 1 To enable or verify whether the Configuration Save/Restore option is enabled fo r a node, invoke the
cnfswfunc command on the node CLI (Command Line Inte rface ). The ou tput of this co mmand on a BPX
8600 is shown in Figure 13-4.
Note Step 1 is only used on BPX and IGX nodes.
Note The CWM ConfigSave and Restore feature must be enabled on the BPX and IGX nodes.