5 Configuring Access Point Settings

Table 16. Valid AP Configuration

 

 

Field

Description

Channel

The Channel defines the portion of the radio spectrum that the radio uses for

 

transmitting and receiving. The range of channels and the default channel are

 

determined by the Mode of the radio interface and the country in which the

 

APs operate.

 

In the United States, IEEE 802.11b/802.11g modes (802.11 b/g) support use

 

of channels 1 through 11 inclusive, while IEEE 802.11a mode supports a

 

larger set of non-consecutive channels (36,40,44, 48, 52, 56, 60, 64, 149,

 

153, 157, 161, 165).

 

Interference can occur when multiple access points within range of each

 

other are broadcasting on the same or overlapping channels. The impact of

 

this interference on network performance can intensify during busy times

 

when a large amount of data and media traffic is competing for bandwidth.

 

If you select auto, the AP scans the RF area for occupied channels and selects

 

a channel from the available non-interfering, or clear channels.

 

If you specify a channel, make sure that the channel does not interfere with

 

the channel that neighbor APs use.

 

NOTE: The channel you set for an AP in the valid AP database is fixed and

 

takes precedence over initial channel selection done by the AP and any

 

automatic channel planning done by the switch.

 

NOTE: For radios that use 802.11a mode, some countries have a regulatory

 

domain that requires radar detection. For these countries (based on the

 

country code setting), the radio automatically uses the 802.11h protocol for

 

selecting the channel if radar is detected on the statically assigned channel.

 

 

Power

The power level affects how far an AP broadcasts its RF signal. If the power

 

level is too low, wireless clients will not detect the signal or experience poor

WLAN performance. If the power level is too high, the RF signal might interfere with other APs within range.

The default value of 0 indicates that the AP uses the power level set in the AP profile.

NOTE: The power level you set for an AP in the valid AP database is fixed and takes precedence over any automatic power adjustments done by the AP or the switch.

Configuring Valid Access Point Settings 101

Page 101
Image 101
D-Link DWS 3000 user manual APs operate