D-Link DWS 3000 Upgrading the Access Point Software, AP Upgrade Field Description, Server Address

D-Link Unified Access System User Manual

The Current Status of the plan shows one of the following states:

•None—The power adjustment algorithm has not been manually run since the last switch reboot.

•Algorithm In Progress—The power adjustment algorithm is running.

•Algorithm Complete—The power adjustment algorithm has finished running.

A table displays to indicate proposed power adjustments. Each entry shows the AP along with the current and new power levels. To accept the proposed change, click Apply. You must manually apply the power adjustment for the proposed assignments to be applied.

•Apply In Progress—The switch is adjusting the power levels that the APs use.

•Apply Complete—The algorithm and power adjustment are complete.

Upgrading the Access Point Software

The D-Link WLAN Controller Switch can upgrade software on the APs that it manages. To upgrade one or more D-Link Access Point from the switch that manages it, click the WLAN > AP Management > Software Downloads tab.

Figure 52. AP Upgrade

NOTE:The APs automatically reset after the code is successfully downloaded.

Table 19 describes the fields you must complete to upgrade D-Link Access Points.

Table 19. AP Upgrade

Field	Description
Server Address	Enter the IP address of the host where the upgrade file is located. The host
	must have a TFTP server installed and running.
File Path	Enter the path to the directory where the upgrade file is located.
File Name	Enter the name of the upgrade file. You may enter up to 32 characters, and
	the file extension ".tar" must be included.

110 © 2001- 2006 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.