L3 Roaming Example

3.Click Submit to save the changes to the L3 Tunnel network configuration.

4.Check the L3 Tunnel Status to make sure the L3 Tunnel Status is Configured.

5.To apply the profile changes to the APs, click Administration > Advanced Configuration > AP Profiles.

6.Select the Default profile check box and click Apply.

When you update the profile, the WCS adds the L3 Tunnel network to the Managed APs that use the default profile.

Configuring DHCP Relay and the DHCP Server

Unless you use the WCS as a DHCP server or use static IP addresses for all devices, you must enable DHCP relay on the switch so that the switch can forward DHCP requests from the roaming wireless clients to the DHCP server on your network.

If you choose to use the WCS as a DHCP server for wireless clients, you must configure the DHCP server and the address pool for wireless clients.

Configuring the Relay Agent

Use the following command in Global Config mode to enable BootP and DHCP relay on the switch:

bootpdhcprelay enable

Use the following command in Global Config mode to specify the IP address of the BootP or DHCP server that will assign IP addresses to wireless clients:

bootpdhcprelay serverip 192.168.30.2

Configuring DHCP Relay and the DHCP Server 197

Page 197
Image 197
D-Link DWS 3000 user manual Configuring Dhcp Relay and the Dhcp Server, Configuring the Relay Agent