Table 27. Managed Access Point Status
Field | Description |
IP Address | The network IP address of the managed AP. |
|
|
Software Version | The software version the AP is currently running. |
|
|
Age | Time since last communication between the WDS and the AP. |
|
|
Status | The current managed state of the AP. The possible values are: |
| • Discovered - The AP is discovered and by the switch, but is not yet |
| authenticated. |
| • Authenticated - The AP has been validated and authenticated (if |
| authentication is enabled), but it is not configured. |
| • Managed - The AP profile configuration has been applied to the AP and |
| it's operating in managed mode. |
| • Failed - The WCS lost contact with the AP, a failed entry will remain in |
| the managed AP database unless you remove it. Note that a managed AP |
| will temporarily show a failed status during a reset. |
|
|
Configuration | This status indicates if the AP is configured successfully with the assigned |
Status | profile. The status is one of the following: |
| • Not Configured - The profile has not been sent to the AP yet, the AP |
| may be discovered but not yet authenticated. |
| • In Progress - The switch is currently sending the AP profile |
| configuration packet to the AP. |
| • Success - The entire profile has been sent to the AP and there were no |
| configuration errors. |
| • Partial Success - The entire profile has been sent to the AP and there |
| were configuration errors (for example, some configuration parameters |
| were not accepted), but the AP is operational. |
| • Failure - The profile has been sent to the AP and there were |
| configuration errors, the AP is not operational. |
|
|
Profile | The AP profile configuration currently applied to the managed AP, the |
| profile is assigned to the AP in the valid AP database. |
| NOTE: Once an AP is discovered and managed by the WCS, if the profile is |
| changed in the valid AP database (either locally or on the RADIUS server) |
| the AP must be reset to configure with the new profile. |
|
|
Radio | Shows the wireless radio mode that each radio on the AP is using. The |
| |
| |
|
|
Channel | Shows the operating channel for the radio. |
|
|
Authenticated | Shows the number of wireless clients associated and associated with the |
Clients | access point per radio. |
|
|
NOTE:You can sort the list of APs by any of the column heading. For example, to sort the APs by the profile they use, click Profile.
Viewing Detailed Managed Access Point Status
To view detailed information about an AP that the switch manages, select the MAC address of
the AP from the
124 © 2001- 2006