D-Link Unified Access System User Manual

To enable AP authentication on the WCS, click Administration > Basic Setup. From the Global tab, check the AP Authentication box, then click Submit to apply your changes.

Figure 34. Requiring AP Authentication

To enable AP authentication from the CLI, access Wireless Config mode and enable authentication:

(switch-prompt) >enable Password: (switch-prompt) #config

(switch-prompt) (Config)#wireless

(switch-prompt) (Config-wireless)#ap authentication

Using the Local Database for AP Validation

To use the local Valid AP database, set the AP Validation to local, add APs to the database, and configure the settings for the APs in the database. All of the configuration takes place on the switch.

To set up the local database for AP Validation, use the following steps:

1.From the Administration > Basic Setup > Global page, make sure AP Validation is set to Local, which is the default.

2.Click Submit if you made any changes.

3.Click the Valid AP tab.

72 © 2001- 2006 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.

Page 72
Image 72
D-Link DWS 3000 user manual Using the Local Database for AP Validation, Requiring AP Authentication