DigiTech C0408 Line C.O.S. Programmlng, Line COS Menu Selections, COlPABX Typical line connection

IMI 66-083 System Progamming

•Selection 4: Load/Save COS data (on cassette tape and the transfer of this data through remote programming)

•Selection 5 : Serial communication parameters (for data port A and data port B)

•Selection 6: COS data printout

•Selection 7: Set clock date/time.

•Selection 8: SMDA programming (Configures the Station Message Detailed Accounting feature. Also refer to page 4-59 for an explaination of call costing and SMDA reporting.)

• Assign Area Codes / Prefixes to Bands

•Enter band number O-7, enter 0 for no band, or enter area codes or prefixes as 200-999.

•Set Dial Time Limit (non-costed time allowed for dialing to take place in l/l 0 min)

•Set Answer Time Limlt (non-costed time allowed for call to ring and be answered in l/l 0 min)

•Define Department Numbers (Calls can be costed on a department basis by department basis.)

. Assign Stations to Departments (for costing by department)

•Set Account Codes (Calls can be identified by account code for costing by catagory.)

•Clear Account Codes

•Enable Account Codes Wiih Verify (User account code entry is compared with programmed account code.)

•Enable Account Codes Without Verify (User account code entry is not compared with programmed account code.)

•Disable Account Codes

9 Account Code Message Display Parameters (LCD speakerphones can prompt users for account code entry on incoming and/or outgoing calls.)

•Account Code Message Display Time

•Maximum Account Code Length

9 Call Cost Tables

•Call Cost Exception Tables

. Automatic Reports (Call cost reports can be produced for prfnting.)

•SMDA Delete By Attendant (allows attendant to delete SMDA records)

•SelectIon 9: SMDR print parameters (enables Or disables call cost reporting along with a Station Message Detail Report).

•Selectlon 10: LogicaVphysical assignments - stations (For example; assign station extension 25 to station port 25. Also refer to the discussioin provided on page 3-6.)

•Selection 11: Logical/physical assignments - lines (For example; assign line 1 to line port 1. Also refer to the discussion on page 3-5.)

•Selectlon 12: Automatic station relocation (allows individual features to be physically relocated without losing their programming parameters and extension asignments)

•Selection 13: Feature inhibit programming (allows individual features to be inhibited)

•Selection 14: Enable all inhibited features (will enable all features inhibited with selection 13)

•Selection 15: LCD messages (programs the messages for the LCD messaging and response messaging features)

•Selectlon 16: Software version number (identifies the software release version of the system)

Line C.O.S. Programmlng

1.Line Type

2.Line Group Assignment (reads “Reserved” if no hybrid strap is installed)

strap installed)

3.Line Dialing Mode

4.Line Privacy Release

5.Line Toll Restriction Table Assignments

6.Line Abandoned Hold Release Time

7.Set Up a Line ( Using a Model Line )

8.Assign Name to Line

9.Assign Line to Department

10.Exclusive Hold

11 .Voice Mail Line I.D.

12.D.I.S.D. Assignments

13.Return To Previous Menu

Enter Selection:

LINE COS MENU SELECTIONS

In each line COS menu selection, after choosing the feature, enter all line port numbers which are to be assigned to it.

•Selection 1: Llne type (specifies the characteristics of the line port)

9 Disabled

•Auxiliary (Configures port for installation of external paging amplifier.)

. COlPABX (Typical line connection)

4-88