DigiTech C0408 system manual Station Speed Dial Programming, Programming Automatic Redial Button

System Operation IMI 66-083

STATION SPEED DIAL PROGRAMMING

Station speed dial numbers can be stored by the station user for later redial. The storage locations are keypad digits 0 through 9 on the station. Before attempting to program, decide on the following items:

(1)the number or feature to be stored, (2) which storage location will be used (0 - 9), (3) the circuit that the call will go over (individual line or intercom).

To program numbers,

•Press ITCM +K +K 2.

•Dial a memory location (0 through 9). Listen for fast tone bursts.

•.Press specific line button, ITCM button, or dial 1 - 4 for line groups, to store circuit pre-selection.

-OR-

*If no circuit pre-selection is desired, dial 0 (system will choose last line used at calling station or prime line if one is assigned to calling station).

•Dial the number sequence to be stored. (Up to sixteen digits can be stored. Valid digits include 0 - 9, #, and +K.)

• To store a pause if required, press HOLD.

•To store a hookflash if required, press TAP.

Example: Store a telephone number under location

0. The number is 1(804)555-2222. Program as follows:

ITCM, +, *, 2,0, Line Button, 1,&O, 4,5,&S, 2,2,2,2.

To store another number,

•Press TRANSICONF.

•Press next speed dial location.

•Make line pre-selection if desired.

•Dial number for storage.

•Repeat this procedure until all desired numbers are stored.

To end station speed dial programming, o Press MNTR (SPKR).

DIRECT STATION SELECTION/BUSY LAMP FIELD (DSWBLF) PROGRAMMING

One-button intercom calling with visual indication of telephone status can be programmed as programmable buttons not assigned to lines.

To program DSS,

•Press ITCM +# ++ 3.

•Press programmable button to be programmed as DSS button.

•Dial extension number.

. Repeat last two steps for all desired extension numbers.

To end DSS programming,

•Press MNTR (SPKR).

NOTE: An autodial number can also be programmed as a secondary function at every DSSBLF memory location. See Automatic Dialing instructions for programming details.

PROGRAMMING AUTOMATIC REDIAL BUTTON

The system will allow the last previously dialed number to be automatically and repeatedly redialed for approximately ten minutes. A programmable button is defaulted to provide this feature. A different programmable button can be assigned for this function if desired

To program another programmable button for use as an automatic redlal button,

Press ITCM G% % 1.

To remove function assignment,

Press current assigned programmable button, then press TRANS/CONF button.

Press desired programmable button to receive function. Listen for fast tone burst.

Press #to assign function.

Press MNTR (SPKR) to end.

PROGRAMMING RESPONSE MESSAGE BUTTON

The system will allow a station user to make a non-verbal response to an intercom call or to a secure off -hook voice announcement. This response will provide a preprogrammed message for display at the * calling station if it is an LCD speakerphone.

To assign programmable button for non-verbal one-button response,

•‘PresslTCM+++l.

•Press desired programmable button. 0 Dial 5.

0 Dial message location number (1-O).

NOTE: The response message is preprogrammed and made available for use by attendant programming.

•Press MNTR (SPKR) to end.

0 Label button.