DigiTech C0408 system manual BENEFITt, DigiTech Software Enhancement, Console Feature

DigiTech Software Enhancement TAB080

FEATURE

11

Console

Feature

-continued

BENEFITt

The first console (the one installed at the logic-paired port) extends the autodial buttons of the paired telephone by 32 and provides DSS/BLF coverage for station ports 10 through 41. Additionally, the first console provides COS programmlng buttons Cl0 through C41 when needed. Refer to the programming overlay that is included at the end of this publication.

The second console (the one installed at the programmed station port) provides DSS/BLF coverage as follows:

•On a Cl 632 with two CM408 expansion modules, the first 16 buttons are automatically assigned (defautted) to station ports 42 through 57.

•On a Cl 632 with one CM408 expansion module, the first 8 buttons are automatically assigned (defaulted) to station ports 42 through 49.

•On any other smaller station capacity system, all buttons are unassigned.

•All 32 buttons on the second console are programmable for DSS and/or autodial use.

The second console provides COS programming buttons C42 through C57 when needed. Refer to the programming overlay that is included at the end of this publication.

It is important to remember that when a second-console assignment is made or cleared, the console button mapping and autodial values are reset to match the default values, or any previously programmed ones, for the active feature. This means that when the second-console feature is cleared, the console installed at that port complements the telephone that is installed at the logic-paired port instead of the one at the port set with the second-console programming. The console buttons are automaticallv reassigned (defaulted) to stations 10 through 41 or to the maximum station number on system. Figure 1 illusrates‘a typical dual console configuration.

A second console can be installed and programmed without having a first console installed at a logic-paired port. The

button assignment is automatically defautted for ac second console but can be reprogrammed as

required. This configuration is convenient for adding a console to an existing tele- phone installation that already has

the logic-paired port occupied. Do not use this configuration for station ports 10 and 12 because the console buttons will not be usable for programming.

Typi&l DigiTech Telephone (-Atgt8tbnPtilo)

Figure 1. Dual Console Wiring

Continued on next page. . .