DigiTech C0408 system manual Section Class of Service Programming, System’Programming

System’Programming IMI 66-083

SECTION 2

CLASS OF SERVICE PROGRAMMING

Class of service programming is usually performed by the system installer. Class of service programming procedures provide the means for programming all of the system variables. The installer may elect to program only the line attributes and allow the

Enter the base level programming mode.

remainder of the system variables to remain set to their defautt values.

Perform class of service programming as shown below.

Mark the desired selections in the charts to record programming needs.

o

TYPICAL FEATURE PROGRAMMING SEQUENCE

\

Automatic Hold For Intercom feature enabled, pressing another intercom button or line button while already on an intercom call will automaticalfy place this existing call on hold .

\

10- 57: Dial 10 r next station fea

Dial ~6 + for configuration

) Dial a feature code to select a programming parameter.

A current program setting is indicated by a lighted LED next to the applicable programming button. When a toggle (ON/OFF) action is provided by a single button, the lighted LED indicates when the feature is active.

If a tone burst sounds three times during programming, it denotes an erronous input. Programming can be continued after an error without ending and re-entering the programming mode from base level..

@Press +k to return to the most previous programming level. Each press returns to the next previous programming level.

Press SPKR to end procedure.

4-2