DigiTech C0408 system manual Automaticdialing, Speed Dialing, Automatic Redialing

IMI 66-083 S y s t e m Operatjon ,

To tone call a DSS number,

•Liit handset.

•Press programmable button that is programmed for desired station.

•Press ITCM. Called telephone will ring.

NOTE: The lights (LEDs) adjacent to programmable buttons indicate status of DSS telephones: DARK indicates idle telephone, STEADY-ON indicates telephone in use. FLASHING indicates station is ringing (providing station monitoring is enabled).

SECURE OFF-HOOK

VOICE ANNOUNCE (SOHVA)

To dial system speed dial numbers,

0 Press *.

•Press keypad digits 01 - 99 for desired system

speed dial number. -OR-

If on line listen to dial tone,

•Press HOLD +# and then press desired keypad digits 01 - 99.

AUTOMATICDIALING

To automatically dial numbers,

•Press desired programmable button.

•If desired programmable button is also programmed for DSS (one-button intercom) calling.

To make a secure voice announcement to another station that is off-hook or busy on a call,

If the calling station has a SOHVA originate button programmed,

Lift handset.

Make intercom call and hear busy signal.

Press SOHVA button and hear SOHVA warning tones (six quick tone bursts). If busy signal continues, message cannot be delivered until called party picks up handset; however, called station will sound intercom ringing.

Deliver message. Wait on line for reply.

If the calling station ddes not have a SOHVA button programmed,

•Lii handset.

•Make intercom call.

•Hear SOHVA warning tones (six quick tone bursts).

If busy signal sounds, message cannot be delivered until called party picks up handset; however, called station will sound intercom ringing.

If calling from an LCD speakerphone,

•Called station may send non-verbal message response for display. As non-verbal response message is displayed, calling station is disconnected.

SPEED DIALING

To dial station speed dial numbers,

•Press keypad digit 0 - 9 for desired personal speed

dial number. OR-

If on line listen to dial tone,

•Press HOLD and then press desired keypad digit

o-9.

•Press HOLD and then press desired programmable button.

AUTOMATIC REDIALING

To activate automatic redial,

•Press programmable button pre-programmed for that purpose. ITCM light flutters while auto redial is active.

•Number will be dialed once a minute for ten minutes.

If called number Is busy,

•Press auto redial programmable button to immediately start the re-dial cycle.

If call is answered,

•Take control by liiing handset. If control is not taken, call will drop.

To cancel automatic redial,

•Press auto redial button, lift and replace handset, or press any station button.

NOTE: Any user originated station activity during automatic redial will cancel the feature.

LAST NUMBER REDIAL

The last number previously dialed can be automatically redialed with one-button or two-button action.

•Dial #. (If on-line listening to dial tone, press HOLD then dial #.)

•Listen for ringing or busy tone.

-Ringing tone: When party answers, Iii handset.

-Busy tone: Press MNTR (SPKR) to disconnect.

5-3