DigiTech C0408 Tab, Featurebenefits, Account Code Message Display Time, Account Code Entry

TAB 099 DigiTech System Software Enhancements

FEATUREBENEFITS

’xwntvalid account codes that can be stored (as shown in the following table). Be aware that when you

L Jes (cont.) change the Verified Account Code Length, the list of Valid Account Codes is emptied.

-

4

56

790

9,lO

11,12

13,14

15,16

NufuberofValld Account Codes

1000

400

266

200

160

133

114

100

ACCOUNT CODE MESSAGE DISPLAY TIME

When account codes are enabled, LCD telephones will prompt users with an “account code” message, which is cleared at the end of the programmable display time. If the account codes are forced and the call is outgoing, then the line is dropped at the end of the display time if a valid account code is not entered. Valid range for the display time is 1 to 20 seconds. If display duration is ever set for zero seconds, time-out for account code entry prior to the line being dropped defaults to 5 seconds.

ACCOUNT CODES AND EMERGENCY NUMBERS

When the Forced Account Codes feature is enabled, emergency numbers may be dialed without account code entry. You may define up to three programmable emergency numbers. Minimum length of an emergency number is 1 digit; maximum length is 12 digits. Users may dial emergency numbers manually, or through system speed dial, personal speed dial, last-number redial, or automatic redial -- with or without account code entry.

ACCOUNT CODE ENTRY

Users may enter account codes after they select a line, or they may enter the code without selecting a line at all. When a code is entered without line selection, the code will apply to any line subsequently selected at that station for the next call attempted manually or through automatic redial, system speed dial, personal speed dial, or last number redial.

If an Account Code button is programmed at the telephone, the user can press this button for automatic account code entry. If no such button is programmed, the user must press ITCM and then dial +K 0 4. The prompt “Account Code” will appear on the top line of the telephone’s LCD. The user then enters account code digits to be verified, followed by any additional digits necessary to make up the required length of the account code.

If the system is set for Verified Account Codes, a verification attempt will be made after the entire code has been entered. Failure by the system to verify the code will cause “Error” to display in the LCD. The user may re-enter account code digits at this point. If the verification attempt is successful (or if the system does not require that the code be verified), the LCD will return to the normal display of date and time.

A user may clear an account code stored at a programmable button by pressing the Account Code button twice, or by pressing ITCM f 0 4 SPKR.

3