EMC P/N 300-002-803 manual Updating the QLogic CEE

Installation Steps

Table 1 Installation steps (page 3 of 3)

Step	Instructions		For Fibre Channel, refer to	For Fibre Channel over	For iSCSI, refer to
				Ethernet (FCoE), refer to
5	Install the firmware.
	There are two states:
	•	Wrong	The adapter firmware is part of	The adapter firmware is part of	“Updating the QLogic firmware
		firmware	the Linux driver and cannot be	the Linux driver and cannot be	for iSCSI adapters” on page 131
			altered..	altered.
			Proceed to Step 6.	“Updating the QLogic CEE	Once corrected, proceed to Step
					6.
				/Menlo firmware for FCoE
				adapters” on page 130
				Once corrected, proceed to Step
				6.
	•	Correct	Proceed to Step 6.	Proceed to Step 6.	Once corrected, proceed to Step
		firmware			6.
6	Connect to the		“Zoning and connection planning	“Zoning and connection planning	“Zoning and connection planning
	storage.		in a Fibre Channel or Fibre	in a Fibre Channel or Fibre	in an iSCSI environment” on
			Channel over Ethernet	Channel over Ethernet	page 135
			environment” on page 134	environment” on page 134
7	Reconfigure		“Device reconfiguration	“Device reconfiguration	Proceed to either “Device
	the device.		procedures for FC and FCoE” on	procedures for FC and FCoE” on	reconfiguration procedures for
			page 195	page 195	the iSCSI 3.x driver” on page 196
					or “Device reconfiguration
					procedures for the iSCSI 5.x
					driver” on page 198

26

EMC Host Connectivity with QLogic FC and iSCSI HBAs and FCoE CNAs for the Linux Environment