INSTALLING THE MX-4 DV

USING HEADPHONES

Using Headphones

25

To use headphones, connect them to the Headphone jack, which is located on the middle of the unit. The jack accepts standard stereo headphones with a miniature plug. If your headphones have a large plug, you need an adapter to switch it to a miniature plug.

VCR Selector Switches

Many VCRs have an input selector switch that routes between Line (or AUX, EXT, A/V, or S) and Tuner. Here are some examples.

If a device has a switch similar to one of these, set the switch to the LINE position.

Some VCRs have more than one VIDEO IN jack (for example, one might be Composite and the other Y/C). Set the switch to match the jack you are using as the connector to the MX-4 DV.

General Notes

When connecting video and audio outputs from source devices, most of the time you’ll probably connect to corresponding jacks on the MX-4 DV rear panel. For example, if you connect the video to the VIDEO IN jack labeled “1,” you’ll most likely connect the audio to the AUDIO IN jack also labeled “1.” However, this is not a requirement. You might use non-corresponding jacks — for example, you might connect the video from one source to VIDEO IN 1 but connect the audio from the same source to AUDIO IN 2 if you want to control the audio and video separately.

Remember, DV devices carry the audio and video signal (as well as a machine control signal) on the same connection.

Page 29
Image 29
FOCUS Enhancements MX-4DV manual Using Headphones, VCR Selector Switches, General Notes