HP 8000 s manual Hardware Type, Hardware Device, Installation, ZZ Error

Message	Description		Recommended Action
53.XY.ZZ ERROR	Indicates that a memory error		Verify that the DIMM board is
DIMM SLOT Y	occurred during the		installed correctly and the
	configuration and validation of		DIMMs are configured
	DIMM memory.		correctly. Turn the printer off
			and on to reset the printer. If
	X Hardware Type		necessary, remove and
	0	ROM	replace the DIMM that caused
	1	RAM	the error. For more
			information about installing
	Y Hardware Device		and configuring DIMMs, see
	0	Onboard ROM/RAM	appendix A, “DIMM
	1	DIMM slot 1	Installation.”
	2	DIMM slot 2
	3	DIMM slot 3	If the condition persists,
	4	DIMM slot 4	contact a local authorized HP
	5	DIMM slot 5	dealer or service
	6	DIMM slot 6	representative for service.
	7	DIMM slot 7
	8	DIMM slot 8

ZZ Error

0 Unsupported memory

1 Unrecognized memory

2 Unsupported memory size

3 Failed RAM test

4 Exceeded maximum RAM size

5 Exceeded maximum ROM size

6 Invalid DIMM speed, check DRAM

7 DIMM is reporting information incorrectly

10 DIMM address conflict

11 PDC XROM out of bounds

12 Could not make temporary mapping

13 Invalid RAM type

14 DIMM not paired properly

EN Printer Messages 133