HP 8000 s manual Messages

Problem	Cause and Solution
(The printer is on, but not	If you are using AppleTalk, verify that the AppleTalk
receiving data (Data light	name matches the name on the configuration page.
does not blink and	Print the configuration page. Go to the Chooser menu.
nothing prints),	Select the printer type. In the list box, select the printer
continued)	name that matches the printer name on the
	configuration page. Select the printer port icon. When
	you close the Chooser menu, the settings will be saved.
The printer is on and	READY is not displayed on the printer control panel.
receiving data (Data light	Press GO to bring the printer online.
blinks), but nothing prints
	The levers inside the front door of the printer might not
	be latched. Verify all levers inside the front door are
	properly latched and close the front door.
	The Data indicator is flashing. Wait for the Data
	indicator to stop flashing. The printer is still receiving
	data.
	The printer might be out of toner. Check the printer
	control panel display for TONER OUT REPLACE <Color>.
	For more information on replacing the toner cartridge,
	see the installation guide included with the toner
	cartridge.
	The imaging drum life might be exceeded. Check the
	printer control panel display for DRUM LIFE OUT
	REPLACE DRUM KIT. For more information on replacing
	the drum kit, see the installation guide included with the
	drum kit.
	Check the printer control panel for messages. For more
	information on resolving printer control panel
	messages, see chapter 7, “Printer Control Panel
	Messages.”
	The parallel port might have an MS-DOS timeout error.
	Add a MODE command to the autoexec.bat file. For
	example, in MS-DOS 4.0 or later, use MODE LPT1: B.
	For earlier versions of MS-DOS, use MODE LPT1: P.
	Both examples are for a printer connected to LPT1. See
	the MS-DOS documentation for more information.

EN Printer Response Problems 177