HP 8000 s manual Capacity, see Supported Media Weights and Sizes for

Problem	Cause and Solution
(Media does not feed	The input tray is overfilled. Remove excess media from
from tray 4, continued)	the input tray. For more information on input tray
	capacity, see “Supported Media Weights and Sizes for
	Input Trays” in chapter 3.
	The power cord is not firmly plugged into the printer,
	tray 4, and the power receptacle. Remove and
	reconnect the power cord.
	Verify that the cables are firmly attached between tray 4
	and the printer. Also, verify that the cables are
	connected to the correct connector. For more
	information on connecting the cables between tray 4
	and the printer, see the getting started guide.
	The paper rollers might need to be cleaned. Open the
	lower right door, pinch together the release levers on
	the end of the rollers, and slide the rollers off their
	spindles. Clean the rollers with a hand wipe. Reinstall
	the rollers by holding the roller by the levers and sliding
	the rollers onto the spindle until the rollers click into
	place.
	The media does not meet the specifications for this
	printer. For media specifications, see “Supported Media
	Weights and Sizes for Input Trays” in chapter 3.
Transparencies or glossy	Verify the correct media type is selected in the printer
paper will not feed from	driver or application. Or, if you are trying to print from a
trays 1, 2, or 3	particular input tray, verify that the input tray from which
	you are trying to print is selected in the printer driver or
	application.
	Verify the media type configured in the printer control
	panel for the input tray matches the media loaded in the
	input tray. For more information on configuring the
	media type, see “Configuring Media Type and Size” in
	chapter 2.
	The input tray is overfilled. Remove the excess media
	from the input tray. For more information on input tray
	capacity, see “Supported Media Weights and Sizes for
	Input Trays” in chapter 3.

170 8 Solving Printer Problems EN