HP 8000 s manual Cleaning the Density Sensor, To clean the density sensor and erase lamp

Cleaning the Density Sensor

Clean the density sensor after replacing the imaging drum and when printed colors are inaccurate.

To clean the density sensor and erase lamp

1Open the upper door on the right side of the printer.

2On the inside of the door, locate the density sensor and the density sensor brush. Use the brush to brush off toner particles from the density sensor and the erase lamp. Then replace the brush.

Note

You can also use a hand wipe to clean the density sensor. To prevent scratches on the sensor, do not use any paper products, such as tissue or paper towels, to clean the sensor.

3Close the upper right door.

EN Print Quality Problems 197