Laser/scanner

WARNING! ESD sensitive component.

1.Before proceeding, remove the following components:

●DIMM cover. See DIMM cover and DIMM on page 57.

●Formatter cover. See Formatter cover and formatter PCA on page 60.

●Rear-door assembly. See Rear-door assembly on page 62.

●Left cover. See Left cover on page 66.

●Top-right cover. See Top-right cover on page 73.

●Control panel. See Control panel on page 74.

●Top cover. See Top cover on page 84.

2.Release one tab (callout 1) on the air duct, and then lift the air duct (callout 2) out of the product. Figure 2-93Remove the laser/scanner (1 of 5)

1

2

ENWW

Removal and replacement procedures 107