3.Disconnect one connector (callout 1; J14), release the wire harness from the guide (callout 2), and then remove two screws (callout 3).

Figure 2-47Remove the front-right and right-side cover assembly (2 of 6)

3

2 1

4.Slightly push the cover assembly toward the front of the product to release it, and then carefully rotate the cover away from the product.

CAUTION: Do not damage the covers or the cartridge-door assembly (if you did not remove it) when you rotate the cover assembly away from the product.

Do not dislodge the power-switch assembly (callout 1) when you rotate the cover assembly away from the product.

Figure 2-48Remove the front-right and right-side cover assembly (3 of 6)

1

ENWW

Removal and replacement procedures 77