Table 3-8Event log only messages (continued)

Event log message

Description

Comments

 

 

 

 

13.02.00

Jam inside the top cover

For jam location information, see

 

 

 

Jam locations on page 220.

 

 

If the error persists, a sensor might

 

 

 

be damaged. See Paper-path test

 

 

 

(and automatic sensors test)

 

 

 

on page 136 or Sensor test

 

 

 

(interactive) on page 137.

 

 

 

 

13.98.00

Paper jam open input trays

For jam location information, see

 

 

 

Jam locations on page 220.

 

 

If the error persists, a sensor might

 

 

 

be damaged. See Paper-path test

 

 

 

(and automatic sensors test)

 

 

 

on page 136 or Sensor test

 

 

 

(interactive) on page 137.

 

 

 

 

14.X

Feed roller error

 

 

 

 

 

 

54.01

The humidity-environment sensor (TH3)

1.

Make sure that the product is in an

 

is abnormal.

 

environment that meets the

 

 

 

specifications in Environmental

 

 

 

specifications on page 309.

 

 

2.

Make sure that connector J1803 is

 

 

 

fulley seated on the ECU.

 

 

3.

If the error persists, replace the

 

 

 

environment sensor. See Main fan,

 

 

 

fan duct, and environmental sensor

 

 

 

on page 98.

 

 

 

55 901C

DCC restored

DCC NVRAM was restored from the

 

 

formatter.

 

 

 

 

68 8X04

The permanent storage date does not

 

 

 

match the engine.

 

 

 

 

 

 

68 8X05

The permanent storage date does match

 

 

 

the engine.

 

 

 

 

 

73.00.00

Printer error

Power cycle the product.

 

 

 

8x7345

Disk clean successful

X denotes the slot number (0 is internal).

 

 

 

8x7346

Disk clean failed

A hard disk or compact flash disk

 

 

cleaning failed. Usually caused by a

 

 

hardware failure of the disk. X denotes

 

 

the slot number.

 

 

 

 

8x7347

Some of the sanitized disk did not

 

 

 

correctly verify.

 

 

 

 

 

 

88.00.XX

FailCode from engine self-test execution.

 

 

 

 

 

 

218 Chapter 3 Solve problems

ENWW