then the page will print from Tray 2. The product continuously prints test pages as long as the test-page switch is depressed. The product will not print a test page if it is in Sleep mode.

Print formatter test pages

If the engine test was successful with the formatter removed, reinstall the formatter and then print a configuration page to test the functionality of the formatter.

1.Press the Menu button .

2.Press the down arrow button or the up arrow button to navigate to the INFORMATION menu.

3.Press the OK button to select the menu.

4.Press the down arrow button or the up arrow button to navigate to the PRINT CONFIGURATION option.

5.Press the OK button to select the option and print the page.

Fuser test page

This test helps to determine if the fuser needs to be replaced, or if it has exceeded its expected life.

A customer can complete the steps below and describe the results to the HP Customer Care representative. If the page shows no problems, the fuser does not need replacing.

Replace the fuser (see Fuser on page 100) if the page shows the following problems:

●Fuser offset repeats in the boxes on the page

●Lines or streaks on the page (usually down the edges of the page) indicate fuser contamination

1.Press the Menu button .

2.Press the down arrow button or the up arrow button to navigate to the DIAGNOSTICS menu, and then press the OK button.

3.Press the down arrow button or the up arrow button to navigate to the PRINT FUSER TEST PAGE menu, and then press the OK button.

ENWW

Tools for troubleshooting 135