Cassette pickup (Tray 2) solenoid or Tray 1 (multipurpose tray) pickup solenoid

1.Before proceeding, remove the following components:

●DIMM cover. See DIMM cover and DIMM on page 57.

●Formatter cover and formatter PCA. See Formatter cover and formatter PCA on page 60.

●Rear-door assembly. See Rear-door assembly on page 62.

●Left cover. See Left cover on page 66.

●Top-right cover. See Top-right cover on page 73.

●Control panel. See Control panel on page 74.

●Front-right and right-side cover assembly. See Front-right and right-side cover assembly on page 76.

●Lower-right cover. See Lower-right cover and bracket on page 80.

●Top cover. See Top cover on page 84.

●Power switch assembly. See Power-switch assembly on page 96.

TIP: Removing the power-switch assembly makes it easier to disconnect the connectors at the front of the ECU.

● Engine control unit (ECU). See Engine control unit (ECU) on page 110.

2.Release the wire harness from the guides (callout 1), and then remove three screws (callout 2).

CAUTION: Do not try to remove the gear cover after the screws are removed (it is still attached to the solenoid-wire harness).

Figure 2-107Cassette pickup (Tray 2) or Tray 1 (multipurpose tray) solenoid (1 of 3)

2

1

ENWW

Removal and replacement procedures 115