Intel SBCEGBESW10 CLI manual If no permit rule is defined, the default is set to deny

Management ACL Commands

permit (Management)

The permit Management Access-List Configuration mode command defines a permit rule.

Syntax

permit [ethernet interface-numbervlan vlan-idport-channel port-channel-number] [service service]

permit ip-sourceip-address [mask mask prefix-length] [ethernet interface-number vlan vlan-id port-channelport-channel-number ] [service service]

Parameters

•interface-number— A valid Ethernet port number.

•vlan-id— A valid VLAN number.

•port-channel-number— A valid port channel index.

•ip-address— A valid source IP address.

•mask — A valid network mask of the source IP address.

•prefix-length— Number of bits that comprise the source IP address prefix. The prefix length must be preceded by a forward slash (/). (Range: 0-32)

•service — Service type. Possible values: telnet, ssh, http, https and snmp.

Default Configuration

If no permit rule is defined, the default is set to deny.

Command Mode

Management Access-list Configuration mode

User Guidelines

Rules with Ethernet, VLAN and port-channel parameters are valid only if an IP address is defined on the appropriate interface.

The system supports up to 128 management access rules.

Example

The following example permits all ports in the mlist access list.

Console(config)# management access-list mlist

Console(config-macl)# permit

Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide 147