Intel SBCEGBESW10 CLI manual This command has no default configuration

ACL Commands

Parameters

•disable-port— Indicates that the port is disabled if the statement is deny.

•source — Specifies the MAC address of the host from which the packet was sent.

•source-wildcard— (Optional for the first type) Specifies wildcard bits by placing 1s in bit positions to be ignored.

•destination — Specifies the MAC address of the host to which the packet is being sent.

•destination-wildcard— (Optional for the first type) Specifies wildcard bits by placing 1s in bit positions to be ignored.

•vlan-id— Specifies the ID of the packet vlan.

•cos — Specifies the packets’s Class of Service (CoS).

•cos-wildcard— Specifies wildcard bits to be applied to the CoS.

•eth-type— Specifies the packet’s Ethernet type.

Default Configuration

This command has no default configuration.

Command Mode

MAC-Access List Configuration mode

User Guidelines

MAC BPDU packets cannot be denied.

This command defines an Access Control Element (ACE). An ACE can only be removed by deleting the ACL, using the no mac access-listGlobal Configuration mode command. Alternatively, the Web-based interface can be used to delete ACEs from an ACL.

Before an Access Control Element (ACE) is added to an ACL, all packets are permitted. After an ACE is added, an implied deny-any-anycondition exists at the end of the list and those packets that do not match the conditions defined in the permit statement are denied.

If the VLAN ID is specified, the policy map cannot be connected to the VLAN interface.

Example

The following example shows how to create a MAC ACL with deny rules on a device.

Console(config)# mac access-listmacl1

Console (config-mac-acl)# deny 6:6:6:6:6:6:0:0:0:0:0:0 any

Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide 49